+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3)
+--- Forum: CHIPTUNING (https://cartechnology.co.uk/forumdisplay.php?fid=12)
+--- Thread: Sirius32 Chip removal (AM29F200) (/showthread.php?tid=2247)
Sirius32 Chip removal (AM29F200) - Shooting - 03-02-2014
Hi, I tried to remove an AM29F200 chip from a Sirius32 ECU but the tracks have lifted.
The chip and pcb are covered in some sort of lacquer.
Is there an easy way to remove these chips?
wbr
RE: Sirius32 Chip removal (AM29F200) - meroteki - 03-02-2014
Hot air gun
and later solvent or thinner
only
RE: Sirius32 Chip removal (AM29F200) - Shooting - 03-02-2014
(03-02-2014, 12:40 PM)meroteki Wrote: Hot air gun
and later solvent or thinner
only
I'm using a Hot Air Station but the tracks still lifted, what Temp do you recommend for this chip? I used 400 deg.
Thanks
RE: Sirius32 Chip removal (AM29F200) - meroteki - 03-02-2014
Dont worry 400ok
put down cuttex
you apply hot whit cuttex
down flash pul up
later read write 4000 to 7999 0 8000 incluid in ff this is same
cut pin 58 car start
same for all sirius whit ac whitout ac
its easy
RE: Sirius32 Chip removal (AM29F200) - Dudi_1981 - 03-02-2014
? cuttex ?what is it ?
RE: Sirius32 Chip removal (AM29F200) - racin-snake - 03-02-2014
Just use some paint stripper on the 29f200 clean it off and rinse with ipa
desolder wick most of the old solder and they come off easy HTH
OR ........................READ VIA BOOT MODE saves desoldering
RE: Sirius32 Chip removal (AM29F200) - Shooting - 06-02-2014
(03-02-2014, 13:32 PM)meroteki Wrote: Dont worry 400ok
put down cuttex
you apply hot whit cuttex
down flash pul up
later read write 4000 to 7999 0 8000 incluid in ff this is same
cut pin 58 car start
same for all sirius whit ac whitout ac
its easy
(03-02-2014, 19:58 PM)racin-snake Wrote: Just use some paint stripper on the 29f200 clean it off and rinse with ipa
desolder wick most of the old solder and they come off easy HTH
OR ........................READ VIA BOOT MODE saves desoldering
Thanks, but don't know what you mean BOOT MODE?
br