[RUBBER_UNDIES]

Hello friends.

I'm looking to try digiprog 3 on my w211 2003 e270.

The clocks have been changed because of total failure.

The mileage difference between the 2 clocks is 50k

I have now got dashes where the miles should be.

Can digiprog 3 change the clocks mileage so it correlates with the rest of the car thus showing the mileage? And can it be done via obd?

Thanks in advance.

[raull00]

did you try ezs first?

[RUBBER_UNDIES]

did you try ezs first?

I haven't tried anything. I'm a noob on Mercedes .

Is ezs the car's system or the correction software?

Thanks

[sparky001]

Electronic Ignition switch. Mileage needs to be synchronized with cluster. Zero mileage on cluster (Or under 500km), sync EIS to Cluster, Drive Access Authority, Done  

Cheers

[RUBBER_UNDIES]

Electronic Ignition switch. Mileage needs to be synchronized with cluster. Zero mileage on cluster (Or under 500km), sync EIS to Cluster, Drive Access Authority, Done  

Cheers

Thanks Matey.

So, if I reset the mileage to zero with digiprog 3, xentry can then synchronise the clocks to ezs and the rest of the modules?

I'm new to all this. 

Thanks.

[sparky001]

Yes.
 I can't remember exactly how. But yes. Zero cluster mileage, Disconnect cluster for a couple of minutes, then go through EIS personalization... I think