[ROD-BENDERS]

The car was spinning after changing the ECU but now suddenly stopped spinning. What could be causing this? Can I completely remove IMMO from EWS and MSV70?

write the file see if it cranks... if not bridge the ews starter wires ews must be connected

Br

An attempt to upload KESS after 40 minutes throws an error, probably with checksum. I have already uploaded my KESS to this computer several times and there were never errors. But I can try to upload your KTAG file, do you think it will be ok?

If the file was read by ktag it must be written by ktag.
For ews (immo) off it must be boot read and write, cannot be by obd

I upload the original dump read KTAG (NOT KESS). Could you use it to disable IMMO? My computer is already connected to KTAG on the table, it's just waiting for your help!

[maksymw]

I check and let you know

---

The car started, but I have two errors in ISTA. The first from EWS-DDE and the second from a checksum error. And it spins the starter only after bridging 1 & 2 pin. What could be the reason that you have to bridge these pins and these errors will not be eliminated? Could my EWS have been corrupted? I'm thinking about buying a second EWS and uploading ISN from the engine computer to it. Anyway, thank you very much for your help and interest, I am here to help in BMW (except immo).

---

The car started, but I have two errors in ISTA. The first from EWS-DDE and the second from a checksum error. And it spins the starter only after bridging 1 & 2 pin. What could be the reason that you have to bridge these pins and these errors will not be eliminated? Could my EWS have been corrupted? I'm thinking about buying a second EWS and uploading ISN from the engine computer to it. Anyway, thank you very much for your help and interest, I am here to help in BMW (except immo).

[ROD-BENDERS]

I have no idea with the errors maybe your obd write made a corruption somewhere.

Anyway happy the car now starts.

Br

[johann74270]

I check and let you know

---

The car started, but I have two errors in ISTA. The first from EWS-DDE and the second from a checksum error. And it spins the starter only after bridging 1 & 2 pin. What could be the reason that you have to bridge these pins and these errors will not be eliminated? Could my EWS have been corrupted? I'm thinking about buying a second EWS and uploading ISN from the engine computer to it. Anyway, thank you very much for your help and interest, I am here to help in BMW (except immo).

---

The car started, but I have two errors in ISTA. The first from EWS-DDE and the second from a checksum error. And it spins the starter only after bridging 1 & 2 pin. What could be the reason that you have to bridge these pins and these errors will not be eliminated? Could my EWS have been corrupted? I'm thinking about buying a second EWS and uploading ISN from the engine computer to it. Anyway, thank you very much for your help and interest, I am here to help in BMW (except immo).

Hello if the starter work only with shunt
your data key is not ok

[maksymw]

So for it to be OK, I need to encode the key with the new pcf transponder?

[BmwMerc]

try this file for immo off.
ask for pass in pm
pass= thx+rep