[Silva1337]

Hello guys can anybody help me, i supose my dpf is disabled in incorrectly way
because car smoke white smoke always no matters it stands or drive , and blue when i release the gas pedal it only persist only on warm engine , diagnostics shows that regeneration is not enabled but car is in very good condition it wouldnt be due to mechanical problems cause car is in very good condition, so i probably searching who can perform full disable of dpf.. not only backpressure as i think it was made
Bmw edc16c35
please guys do checksum if needed very appreciate im tired with that smoke

[Remap Ross]

You getting any fault codes? are sensors still connected? due you have any dilution of oil with diesel sir?

[Silva1337]

You getting any fault codes? are sensors still connected? due you have any dilution of oil with diesel sir?

Cats and dpf was removed phisicaly from car, sensor still presents it shows 0bars , no errors
no dilutions, everthying fine including antifreeze and oil
im hundred percent sure that it was turned off incorrectly because i work with cars, and seen so many like that when dpf is turned off but regeneration still persist.. in my situation i think is the same

[Remap Ross]

Do you have original file?

[Silva1337]

Do you have original file?

i think yes, this one was mapped

---

im adding original file without anything , it was made egr , flaps, dpf off and + chip (1st file)

[Remap Ross]

Ok will try and get sum time later if no one helps before

[eurofix]

BLOCK EGR MECHANICALLY !!!
Disconect DPF and EGR sensor
little bit mod coresion

---

with ory file reset dpf and oil

---

checksum ok !!!

---

variant 2

[Silva1337]

My egr got blanking kit, what about dpf sensor disconnect can you explain how to do this?can you show me a scheme from realoem?
btw you made stage1 as extrA? it would be welcome hehe i think my remap sucks too.. bit smoky car rebuilded turbo and new injectors..i would like to try another if anyone not lazy to do it
you mean numer 1 and 3 ?
or its number 11 from second link?
and by now which file to use nr 1 or nr 2?
btw aboout services do i need reset oil and dpf services? as you written?
'thanks......

[eurofix]

Use file nom 2 zona dpf an swiches..and dtc

[Silva1337]

What about dpf sensor? maybe you have another remap?