[smercki]

F10 cant code EPS and cant find it in the ecu list

zgw have close port flexray for EPS
you must open with tools32
Open ZGW01.prg run Job status_Flexray_pfad
port state is:
EIN  = open (0x01)
AUS = close (0x00)
after try open port close (AUS)

run job
steuern_flexray_pfad
with argument:
0x00;0x01 (for port 0)
0x01;0x01 (for port 1)
0x03;0x01 (for port 3)
ect..

thank you  EPS appear again and working but i got a fault with flex ray  that's a real fault or it's need ports closed and opend again to remove that fault

good!
error is due because fex-ray is not initialized, but you can ignore it, it does not cause any malfunction

[iyade46]

thank you very much can you see the picture of list of red ecu is that port work too? or it's other wiring work

[smercki]

thank you very much can you see the picture of list of red ecu is that port work too? or it's other wiring work

I think jbox have problem, try change and coding