[elektronik13]

Guys I'm having a little trouble with this emulator, I can't finish the procedure, I've tried it in the car without the complete procedure but it is a non starter, with fault code 4A63 ews tampering, so  no. 1 I wrote the ISN and now reads correct , no.2 set emulator for alignment, ok, next set ECU for new start value, I get no response, where am I going wrong ? Cheers.

here you have the file, The ISN is set to EEEE so that you can enter it into the emulator easier

[al70]

cheers elektronik, should i write this file to the ecu and then perform the procedure again ?

[elektronik13]

cheers elektronik, should i write this file to the ecu and then perform the procedure again ?

You don't lose anything if you try just a little bit of time

[al70]

I don't have the car here, just the ECU that I got in the post, I will try your file, do I need to install the emulator into the ECU for part 3 of the procedure ( set ECU for new start value ? cheers.

[12manux]

i had a similar situation with an engine from e65 ,

i remember i retrived isn from eeprom than writed via kline with aplication from emulator than sync with INPA.


ecu was mailed over as well but the customer never called back so i guess it worked.

cheers

[al70]

i'll try with inpa first

[elektronik13]

I don't have the car here, just the ECU that I got in the post, I will try your file,  do I need to install the emulator into the ECU for part 3 of the procedure  ( set ECU for new start value ? cheers.

save ISN to emulator and install to ecu and test

[al70]

ok, i will try your solution elektronik, will i write the eeprom file you provided first ?

[al70]

i wrote the eeprom file that elektronik13 supplied in post21, wrote the new isn to emulator and installed back to ecu, i'll send it back tomorrow and post result, cheers all

[elektronik13]

i wrote the eeprom file that elektronik13 supplied in post21, wrote the new isn to emulator and installed back to ecu, i'll send it back tomorrow and post result, cheers all

to check if the department is enough to give power to the ecu and the emulator will start or not,
I think it has a diode that indicates the emulator