[virgo79]

Hello
I am trying to Parameterize an Audi A6 with air suspension.
But with 2 modules I am not able to do it. Same error happening everytime. When it does the SVM calculation it shows “No measures are necessary on this vechile”

The fault
“Control Module not Coded” and “No band end programming occurs “ does not goes away.

Tried with older Odis 6.x and Newer Odis 23.x , both gave me same errors. Wasted money everytime for GEKO account.

What could be causing the issue that SVM can not check the coding and Parameters are needed.

I have done Parameterization on these vehicles many times previously it never happened to me.


Please help me with this

[Versus]

Audi A6 : C5, C6, C7, C8 ?

[virgo79]

Audi A6 : C5, C6, C7, C8 ?

Hello it is C7 2012 model.

[Versus]

coding 000000 ? You need write coding, and calibrate suspension.

[-Harry-]

he will not be able to write coding, als long as "bandende programmierung" is set in fault memory.

i think you had wrong function selected in odis AND you have do do parameters, coding and calibration in one session.

other way would be using vcp.

[virgo79]

1702489798[/url]']
he will not be able to write coding, als long as "bandende programmierung" is set in fault memory.

i think you had wrong function selected in odis AND you have do do parameters, coding and calibration in one session.

other way would be using vcp.

Thanks for the reply 
I am doing it using as the “Test Plan”. I have done it in many Audi A6 but it is not going through in this car. I understand that all coding, Parameterization and Calibration all has. to done in same session. Do you think that VCP have the parameters for Air Suspension for C7 because I thought it can only be done via SVM.

[mantaxxx]

svm code XCHG34A001