[jvegca1]

I have two Renaults, scenic and megane 2 with C10C3 in ABS and I see that it can be repaired but I can't find information about this fault and how to repair it, could someone help me? thank you.

[vibefm]

There is no C10C3, in abs/esp, all the codes(dtc) start with 5xxx, so you could have:
50C3 aka
DF017 computer : power supply or internal fault
or
DF020 tahimetric index programming

[jvegca1]

[adjunto=181526]

[vibefm]

Change your diagnostic device/software : use Renault CLiP

[jvegca1]

There is no C10C3, in abs/esp, all the codes(dtc) start with 5xxx, so you could have:
50C3 aka
DF017 computer  : power supply or internal fault
or
DF020 tahimetric index programming

You are right, mate, the code C10C3 is equivalent to df017, my question is what is the reason for this error and its repair? thank you

[vibefm]

Check the connections and the condition of the battery terminals.
Check the condition and position of the ABS fuses in the engine fuse and relay box.
Check the 50A power fuse in position 5 on the power fuse board.
Check the 25A fuse F13 on the UPC and the correct locking of the grey 4-track PPHI connector (Vdiag 44) or
test the 25A fuse F8 on the UPC and the correct locking of the black 6-track CM connector (Vdiag 48).
Check the connection and condition of the tab 1 red wire of the grey connector.
Check the connections on the 26-track connector of the ABS computer.
Check the ABS earths on tracks 1 and 4 (attached under the ABS unit) and carry out an inspection of the entire
ABS wiring.
Check the continuity between the fuses and tracks 2 and 3 of the computer connector (+ Before ignition present
on the tracks) and between the UCH and track 18 of the computer (+ After ignition present on the track).