[ClmPsr14]

Good morning,
I am currently working on Ford Fusion 1.6 TDCi 90 hp year 2005 (HHJB engine), which is equiped by Bosch EDC16C34 ecu. 
The car no longer wants to start due to an immobilizer failure. 
I tried several immobilizer removal software, no one offered me solution for this type of ECU on Ford.
Is there a solution to remove immo on this type of ECU?
Fiat Peugeot or Citroen immo removal methods are apparently not compatible on Ford models...
I even tried to install an emulator Julie Ford, but apparently this is not possible,
Support CarLabImmo : "ECU is in a virgin state - no communication with immobilizer, which means the emulator will not work."
I don't know what to do with this car anymore.  Does anyone have a solution for me?
Regards.

[bodzio012]

Read dash and give here, I can make you sychro, or any diagnostic tool and change ecu/initiation

[elektronik13]

whether the failure is caused by a discharged battery

Good morning,
I am currently working on Ford Fusion 1.6 TDCi 90 hp year 2005 (HHJB engine), which is equiped by Bosch EDC16C34 ecu. 
The car no longer wants to start due to an immobilizer failure. 
I tried several immobilizer removal software, no one offered me solution for this type of ECU on Ford.
Is there a solution to remove immo on this type of ECU?
Fiat Peugeot or Citroen immo removal methods are apparently not compatible on Ford models...
I even tried to install an emulator Julie Ford, but apparently this is not possible,
Support CarLabImmo : "ECU is in a virgin state - no communication with immobilizer, which means the emulator will not work."
I don't know what to do with this car anymore.  Does anyone have a solution for me?
Regards.

If the eeprom failure was caused by a discharged car battery, I can repair this eeprom

[ClmPsr14]

Yes, when I received the car it's battery was completely discharged.

[ombra]

You will have to read DASH or CEM to sync immo files otherwise write this in ECM as eeprom is suitable with ford diagnosis providing INCODE and OUTCODE.
Pass.PM.Box.

[ClmPsr14]

Thanks for your feedback ombra! I will try this and keep you informed.

[ClmPsr14]

I did the reading of my dash with Carprog, here in attachement.
It is possible to make it virgin or synchronize it?

[ombra]

I did the reading of my dash with Carprog, here in attachement.
It is possible to make it virgin or synchronize it?

Test file virgin ?

[ClmPsr14]

I'm going to try it,
I've already wrote virgin eeprom that you provided me in my ECM.
I will not receive my diagnostic interface for Ford vehicle (OBD Link EX Usb for Forscan) before 3 days.
I wanted to know if I could have gone faster by working on the dash

[ClmPsr14]

I tried what you advised me to do (Sync dump with incode & outcode), unfortunately it didn't work.
I still havn't found solution that could repair my car